Icom ID-5100E

New2001
6
1
PANEL DESCRIPTION
1
PANEL DESCRIPTION
!2 !3 !4 !5!1
!1 [DUP]
Touch to open the duplex direction setting window.
!2 [TONE]
(Displayed only when in the FM/FM-N mode.)
Touch to open a Tone function setting window.
!3 [REC]
When you insert an SD card into the transceiver’s SD card
slot, touch to start recording a QSO (communication) audio.
!4 [SCOPE]
Touch to open the sweep item setting window.
!5 [≈]
( Displayed only when you select a sweep operation in
[SCOPE](!4).)
Touch to start a single sweeping. ➥
Touch for 1 second to start a continuous sweeping. ➥
While sweeping, touch to stop it. ➥
!7 !8!6
(Displayed only when in the DV mode.)
!6 [RX>CS]
Touch to open the “RX>CS” screen. ➥
Touch for 1 second to set the received station call sign ➥
as the destination (UR) call sign.
!7 [CD]
Touch to open the “RX HISTORY” screen.
!8 [CS]
Touch to open the “CALL SIGN” screen.
!7 !8 !9 @0!6
!9 [SCAN]
Touch to open the DR scan setting window. ➥
Touch for 1 second to start the last used scan. ➥
@0 [MONI]
Touch to turn the Digital Monitor function ON or OFF.
u i o !0@1
@1 [SKIP]
Touch to open the skip setting window for the Access ➥
repeater scan.
Touch for 1 second to set the skip setting in the Func- ➥
tion menu.
@2
@2 !3e
@2 [DSQL]
(Displayed in the DV mode.)
Touch to open the Digital squelch function setting window.
If you set the operating mode to “DV” in the VFO mode,
[DSQL] is displayed instead of [TONE] on the F-3 menu.
[TONE]
( Displayed when an analog repeater is selected in the DR
screen for the EUR or ITR version transceiver.)
While holding down [PTT], touch [TONE] to send the
1750 Hz tone.