31
4
D-STAR OPERATION
New2001 New2001
■ Accessing repeaters
This section describes how to check whether or not you can
access your local area repeater (Access repeater), and if your
signal is successfully sent to a destination repeater.
If your call sign (MY) has not been set, or your call sign
and equipment have not been registered at a D-STAR re-
peater, see pages 24 to 28.
Select your Access repeater (“FROM”)1.
Touch [DR]. q
Check whether or not “FROM” is selected. w
• If “FROM” is not selected, touch the “FROM” eld.
Touch the “FROM” field. e
• Opens the “FROM SELECT” screen.
Touch “Repeater List.” r
• Opens the “REPEATER GROUP” screen.
Touch the repeater group where your access repeater is t
listed. (Example: “11: Japan”)
Touch your access repeater. (Example: “Hirano”) y
• Returns to the DR screen, and the selected repeater name is
displayed in “FROM.”
Even if you select just the repeater name, the repeater call
sign, its frequency, duplex setting, frequency offset and
Gateway call sign are automatically set.
To Next Page
Loading...
