New2001
32
4
D-STAR OPERATION
4
D-STAR OPERATION
Select the Destination repeater (“TO”)2.
Touch the “TO” field. u
• Check whether “TO” is selected.
Touch the “TO” field again. i
• Opens the “TO SELECT” screen.
Touch “Gateway CQ.” o
• Opens the “REPEATER GROUP” screen.
!0 Touch the repeater group where your destination repeater
is listed. (Example: “11: Japan”)
!1 Touch your destination repeater. (Example: “Hamacho”)
• Returns to the DR screen, and the selected repeater name is
displayed in “TO.”
Check whether you can access the repeater3.
!2 Hold down [PTT] for approximately 1 second to access the
repeater.
!3 If you get a reply call, or “UR?” appears on the LCD within
3 seconds, your signal reached your access repeater and
your call was successfully sent from your destination re-
peater.
Successfully sent!
NOTE: See page 43 for status indications after a repeater
system reply is received.
To Next Page
Loading...
