23
4
D-STAR OPERATION
New2001 New2001
■ Ways to Communicate with the DR function
With the DR function, the transceiver has three ways to communicate, as shown below.
NOTE:
• Using the repeater list is required to use the DR
function. (p. 51)
• Before operating in the duplex mode, be sure to
check whether the repeater is busy, or not. If the
repeater is busy, wait until it is clear, or ask for a
“break” using a method acceptable to your local
procedures.
• The transceiver has a Time-Out Timer function
for DV operation. The timer limits a continuous
transmission. Warning beeps will sound approx-
imately 30 seconds before time-out and then
again immediately before time-out.
Local area call
Access repeater
Hamacho
repeater
Hamacho area
Gateway call
Hirano
repeater
Sapporo
repeater
Hirano area Sapporo area
To call through your local area (access) repeater.
To call through your local area (access) repeater, repeater gateway and
the internet to your destination repeater or individual station’s last used
repeater, using call sign routing.
Simplex call
To call another station not using a repeater.
To Next Page
Loading...
