Icom ID-5100E

62
7
MENU SCREEN
New2001
7
62
DUP/TONE...
Settings to access repeaters.
Offset Freq 0.000~0.600.00*
1
~59.995 MHz Sets the frequency offset for duplex (repeater) op-
eration.
Repeater Tone 67.0~88.5~254.1 Hz Selects a tone frequency used to access the repeat-
ers.
TSQL Freq 67.0~88.5~254.1 Hz Selects a tone frequency for the Tone squelch or the
pocket beep function.
Tone Burst OFF or ON
Turns the Tone Burst function ON or OFF.
This function is used to suppress the squelch tail noise
heard from the transceiver's speaker.
DTCS Code 023~754 Selects a DTCS (both encoder/decoder) code for
DTCS squelch or the pocket beep function.
DTCS Polarity BothN, TN-RR, TR-RN or Both R Selects the DTCS polarity for the DTCS squelch or
the pocket beep function.
Digital Code 00~99 Selects a digital code for the Digital Code squelch
function.
Manage Memory Manage your Memory or Call channel data.
Memory CH ALL, A~Z Manages for the Memory channels.
Call CH C0/C1(144):146.010 FM*
2
C0/C1(430):440.000 FM*
2
Manages for the Call channels.
■ Menu items and Default settings
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
MENU SCREEN
*
1
The default value may differ, depending on the frequency band (selected as the MAIN band before entering the Menu screen) and the
transceiver version.
*
2
The default value may differ, depending on the transceiver version.