Icom IP100H - Using a Call History; D Erasing All Log Items

4
CALLING OPERATION
4-7
Using a call history
You can make a call using previously transmitted and
Using a call history
received call settings.
Up to 10 calls can be stored in each TX log, RX log, TX
message log, RX message log, TX telephone log and
RX telephone log.
• Selectable log may differ, depending on the IP1000C's
settings.
q Push [ ] several times to select a desired history
log.
• Tx log: Transmitted call
• Rx log: Received call
• Tx MSG log: Transmitted message
• Rx MSG log: Received message
• Tx TEL log
: Transmitted telephone
• Rx TEL log: Received telephone
w Push [J] or [K] several times to select a desired log
call.
e Push [PTT] to call.
D Erasing all log items
All items in the Tx log, Rx log, Tx MSG log, Rx MSG log,
Tx TEL log and Rx TEL log, can be manually erased.
q Turn OFF the communication terminal if it is ON.
w While holding down [FUNC], turn ON the power.
• When “SET” is displayed, release [FUNC].
e Push [J] or [K] several times to select “CLR.”
r Push [ ].
• “ Deleting…” is displayed, and then “– – –” is displayed
after all the logs are deleted.
t Push [CLR].
• The IP100H restarts.
[PTT]
SET
LOG
CLR
SET
LOG
– – –
Push [
J
]/[
K
]