51
9
INSTALLATION AND CONNECTIONS
y Install the UX-234 on the display’s main board using
the four screws supplied with the UX-234. (Fig. 4)
• Before tightening the screws, be sure to connect the UX-
234’s connector to the display unit’s connector.
u Secure the cable to the UX-234 with a cable tie.
(Fig. 5)
i Clamp the cable with the ferrite EMI filter attached
near the UX-234. (Fig. 5)
Be sure to clamp it tightly.
o Reconnect the four connectors to the display’s main
board.
!0 Replace the gasket, rear case, and screws their
original position.
• Make sure the gasket is properly seated.
CAUTION: DO NOT pinch the cables when clos-
ing the rear case. This could damage the cables.
!1 Adjust the video output cable length and then tight-
en the sealing nut. (Fig. 6)
■ Installing the UX-234 Video output unit (Continued)
UX-234
Video output cable
Connector
Connector
Fig. 4
UX-234
Ferrite EMI filter
Cable tie
Fig. 5
Video output cable
Sealing nut
Fig. 6
To Next Page
Loading...
