To Next Page

To Previous Page

Hardware Configuration

Setting the IP Address from a Keypad

If the current IP address of the controller is not known it can be viewed and changed using a Protege keypad.

1. Connect the keypad to the module network.

2. Log in to the keypad using any valid installer code. The default installer code is 000000.

If the default code has been overridden and you do not know the new codes you will need to default the

controller (see Defaulting the Controller in this document) to reset the code.

Note that this will erase all existing programming as well as setting up the default installer code.

3. Once logged in select Menu 4 (Install Menu) then Menu 2 (IP Menu) and view or edit the IP address, network

mask, and gateway as required.

Once the settings have been changed you must save the settings by pressing the [Arm] key. You will be

prompted to confirm the changes by pressing [Enter]. You must then restart the controller, either through the

menu [4], [2], [2] or by cycling the power, for the settings to take effect.

Protege WX Integrated System Controller | Configuration Guide 35

Other manuals for ICT Protege WX

Questions and Answers:

Need help?

Do you have a question about the ICT Protege WX and is the answer not in the manual?

General