Introduction
This configuration guide provides programming instructions and system communication information for Protege
WX controllers. For installation instructions and technical specifications, see the appropriate controller installation
manual, available from the ICT website.
Controller Editions
This configuration guide includes programming instructions for the following Protege WX controller models:
Product Code Controller Module
PRT-WX-DIN-IP Protege WX DIN Rail Integrated System Controller (IP only)
PRT-WX-DIN Protege WX DIN Rail Integrated System Controller
PRT-WX-DIN-1D Protege WX DIN Rail Single Door Controller
About This Module
The Protege WX controller is the central processing unit responsible for the control of security, access control and
building automation in the Protege WX system. It communicates with all system modules, stores all configuration
and transaction information, processes all system communication, and reports alarms and system activity to a
monitoring station or remote computer.
Flexible module network architecture allows large numbers of modules to be connected to the RS-485 module
network. Up to 250 modules can be connected to the Protege system in any combination to the network, over a
distance of up to 900M (3000ft). Further span can be achieved with the use of a network repeater module.
Protege WX Integrated System Controller | Configuration Guide 5
To Next Page
Loading...
Need help?
General
