IDEAL Networks LanTEK III - Setup for Channel Link Test

LanTEK III 161809 Iss 2
User Manual Page18
3.1.2 Setup for Channel Link Test
A channel link includes all components of a cabling system. It consists of up to 90 meters
horizontal cabling, including patch cords, jumpers, and test adapters at each cable end. The
channel link shown above serves to certify the network installation, including the horizontal
cable line and patch cord.
Channel link testing requires different test Adapters depending on the link under test:
R161056
LanTEK® GG45-Adapter
R161054
LanTEK® TERA-Adapter
R161055
LanTEK® EC7-Adapter
R161053
LanTEK® Cat. 6A-Adapter for RJ-45
R161052
LanTEK® Cat. 6-Adapter for RJ-45
NOTE:
Please visit www.idealnetworks.net for an
up to date full list of test Adapters.
3.1.3 Setup for other Test Methods
Depending on the testing requirements other than permanent link and channel, LanTEKIII
offers various testing configurations:
• Coaxial testing
R161057
LanTEK® Coax-Kit
• Testing of End-to-End (E2E) , Device- or Direct Attach Links:
R160050
& R161053
LanTEK® Industrial Ethernet Kit
& LanTEK® Cat. 6A-Adapter for RJ-45
(both Adapters are required)
NOTE:
Please visit www.idealnetworks.net for an
up to date full list of test Adapters.