IDEAL Networks LanTEK III - Chapter 8. Tone Generator; Enable Tone Generator with Display handset (DH)

LanTEK III 161809 Iss 2
User Manual Page73
8.1.2 Enable Tone Generator with Remote handset (RH)
1. Connect Remote handset (RH) to cable to be tested.
2. On Remote handset (RH) press TONE. The tone mode is enabled. The first line of
the two-line Remote handset (RH) display shows the message TONE. In the
second line, the type of tone signal as well as the feed location is shown in XY
format.
X symbol
(Tone)
Y symbol
(feed location)
L = Low 78 = Pair 78
H = High 36 = Pair 36
W = Warble 54 = Pair 54
12 = Pair 12
Example: L78 = low tone ("Low"), pair 78
NOTE:
The Tone Mode remains enabled until you press Escape.
3. Select the wire pair into which the tone signal is to be fed by switching between
the options with the TONE key.
4. Select the tone signal for the selected wire pair by switching between the
options with <SHIFT>+TONE.