LanTEK III 161809 Iss 2
User Manual Page72
Chapter 8. Tone Generator
The Display handset (DH) as well as the Remote handset (RH) can generate a low tone, a
high tone and an alternating tone, with a rate of 2 Hz between low and high alternating tone
("Warble"), which is recognized by most standard cable locators.
Fig. 91 Typical Application of Tone Generator
The keys WIREMAP, SHIFT and TONE are hard keys. The keys Pair A, Pair B, Pair C, Pair D,
Low, High and Warble are soft keys that are displayed on the Display handset (DH).
8.1.1 Enable Tone Generator with Display handset (DH)
1. Connect Display handset (DH) to cable to be tested.
2. Use Arrow Keys to navigate on ready screen to "Toner" display and confirm with
Enter.
The Tone Mode remains enabled until you press Escape.
3. Use soft keys to select the wire pair (Pair 78, Pair 36, Pair 54 or Pair 12) into
which the tone signal is to be fed.
4. Press SHIFT to select tone signal and enable it with soft keys LOW, HIGH or
WARBLE.
To Next Page
Loading...
