IDEAL Networks LanTEK III - Set Autotest Pref

LanTEK III 161809 Iss 2
User Manual Page27
Overall Passed/Failed Result
The overall result of Autotest is displayed after test series is completed.
Symbol Overall Autotest Result
The overall Autotest receives a passing grade if all single tests have been passed
or passed*.
The overall Autotest receives a failing grade if at least one single test has failed or
failed*.
5.1 Set Autotest Pref
1. Open "Preferences" on start screen.
2. In "Preferences" open Autotest Pref.
3. Use Arrow Keys to navigate to the according Autotest Pref. Use soft key
to enable or disable the selected Autotest Pref. Enabled Autotest Pref are indicated
by green boxes.
Fig. 21 Autotest Pref
4. Press Enter to save the information entered. Escape allows you to exit the menu
without making changes.
Autotest Pref Description
Simple cable ID
Assign name to cable line and set/reset meter reading of tests. The
name can be assigned as simple cable ID or double cable ID (Cable
From/Cable To).
NOTE:
If Simple Cable ID is not enabled, the cable name assigned will be
the default cable ID. In addition to cable name and test meter, an
initial value and a final value can be set, and the way of counting
can be specified.
Stop on Fail
The Autotest is stopped after the first failed test.
Autosave
The LanTEK
®
III Cable Tester automatically names and saves all
results of passed Autotests in the current job folder.
Auto Increment
The test meter for the cable ID is automatically advanced after each
Autotest.
This will permanently
delete the Tests / Jobs
from the tester
Enables confirmation prompt prior to deleting data.