LanTEK III 161809 Iss 2
User Manual Page49
mark the patch cords accordingly.
2. Connect Display handset (DH) and Remote handset (RH) with patch cord for
Remote handset (RH), as shown on the display. Remember which connection
of the patch cord is connected to the Remote handset (RH).
Fig. 59 Patch Cord (RH)
3. Use soft key to initiate calibration. The Remote handset (RH) indicates
calibration, and a progress bar shows the status.
4. Connect Display handset (DH) and Remote handset (RH) with patch cord for
Display handset (DH), as shown on the display. Remember which connection of
the patch cord is connected to the Display handset (DH).
Fig. 60 Patch Cord (DH)
5. Use soft key to continue calibration. The Remote handset (RH)
indicates calibration, and a progress bar shows the status.
6. Perform the same patch cord connections to Display handset (DH) and Remote
handset (RH) as during the previous test steps.
To Next Page
Loading...
