FC6A S
ERIES
MICROS
MART
U
SER
’
S
M
ANUAL
FC9Y-B1722 3-27
3: I
NSTALLATION
AND
W
IRING
Opening and Closing the USB Port Cover
The following procedure describes how to open and close the USB port cover.
Opening the USB Port Cover
1. Insert a flathead screwdriver into the screwdriver slot on the USB port cover and slowly move the screwdriver in the direction
of the arrow to unlock the top lock.
2. Open the USB port cover in the direction of the arrow.
Note: To remove the USB cover, first open the cover in step 2, and then apply force in that same direction to remove the cover.
To communicate with a computer, use the USB cable (model: HG9Z-XCM42).
If you use the USB extension cable (model: HG9Z-XCE21), you can perform maintenance on an FC6A Series MICROSmart installed
in a control panel from the face of the control panel. We recommend securing the USB extension cable to the USB port cover with
a cable tie (HellermannTyton cable tie: T18R) so that the USB extension cable is not disconnected from the FC6A Series
MICROSmart.
USB Port Cover
Screwdriver Slot
To Next Page
Loading...
Need help?
General
