Identiv uTrust 4711F - Cntless_P2 P_Target_Receive

Document Version 1.2
Last revised on
2017-09-26
Page 69 of 92
Reference Manual for uTrust 4701F and uTrust 4711F Readers
6.3.4.18. CNTLESS_P2P_TARGET_RECEIVE
This Escape command is used to receive data from the initiator device. Prior to using this command,
the device should have been successfully switched to target mode using
CNTLESS_P2P_SWITCH_MODES (E9).
Input Buffer:
Offset
Description
Detailed description
0
0xEA
Target Receive
1
RFU
2
RFU
3
RFU
4
0 - No Chaining
1 - Chaining
Chaining byte
5
--
Timeout Low Byte
6
--
Timeout High Byte
Output Buffer:
On successful reception, the entire data from the initiator device would be returned from offset 0x04
Offset
Description
Detailed description
0
RFU
1
RFU
2
RFU
3
0 – No Chaining
1 – Chaining
Chaining
Offset 4 to
offset 4+N
N data bytes
Bytes Received.