Identiv uTrust 4711F - 2 Introduction to the Manual; Objective of the Manual; Target Audience; Product Version Corresponding to the Manual

Document Version 1.2
Last revised on
2017-09-26
Page 8 of 92
Reference Manual for uTrust 4701F and uTrust 4711F Readers
2. Introduction to the manual
2.1. Objective of the manual
This manual provides an overview of the hardware and software features of the uTrust 47x1 F dual
interface smart card readers (uTrust 4701 F and uTrust 4711 F).
This manual describes in detail interfaces and supported commands available for developers using
uTrust47xx F in their applications.
2.2. Target audience
This document describes the technical implementation of uTrust 47x1 F.
The manual targets software developers. It assumes knowledge about ISO 7816, 13.56 MHz
contactless technologies like ISO/IEC 14443 and commonly used engineering terms.
Should you have questions, you may send them to support@identiv.com.
2.3. Product version corresponding to the manual
Product Component
Version
Hardware
1.00
Firmware
1.04 and above