Identiv uTrust 4711F - Contact_Read_Insertion_Counter

Document Version 1.2
Last revised on
2017-09-26
Page 84 of 92
Reference Manual for uTrust 4701F and uTrust 4711F Readers
Output:
For Get/Set guard time, the output will be the Character/Block Guard Time value.
Byte0
Byte1
Byte2
Byte3
Character Guard time in ETU
BIT31-BIT24
BIT23-BIT16
BIT15-BIT8
BIT7-BIT0
DataIn = 82 00 01
DataOut: 00 00 00 18 (4 bytes)
6.3.5.14. CONTACT_READ_INSERTION_COUNTER
This Escape command is supported through the READER_GENERIC_ESCAPE command and retrieves
the number of times a contact smart card has been inserted into the reader.
Input:
The first five bytes of the input buffer follow APDU structure as per [PCSC3-AMD1]. The 6
th
byte is the
Escape code 0x00 to identify the command.
Byte0
Byte1
Byte2
Byte3
Byte4
Byte5
Le
0xFF
0x70
0x04
0xE6
0x01
0x00 (Escape
code)
4 (Insertion counter is a 4
byte value)
Output:
Byte0
Byte1
Byte2
Byte3
Byte4
Byte5
Insertion counter value
SW1
SW2
BIT31-BIT24
BIT23-BIT16
BIT15-BIT8
BIT7-BIT0
0x90
0x00
In case of any error, only SW1 and SW2 set with error status will be returned.