• I had no choice but to raise the main boom to open the dipper stick for shot #3:
• As soon as the main boom angle gets changed you’ll notice a 2
nd
white angle bubble underneath the main boom angle bubble. Match up
the flickering (actual) value with the frozen value. As soon as the actual value turns green you’re OK for shot #3.
• As soon as the actual bubble value turns green, try to catch the laser beam ONLY using the dipper stick.
• I can’t get an on-grade laser catch signal at shots #2 and/or #3:
• Try to get a bigger distance between the rotating laser and the dipper stick laser sensor.
• Make sure that the laser reception field of the Sensor isn’t (almost) horizontal. The closer to horizontal orientation, the less possible it is
to gain an on-grade laser reception.
• Once you are sure you’d have the laser beam on-grade (but it gives you a lost laser message instead) turn the laser catch setting to “Off”
(instead of the actual “Fine”) and confirm the laser catch with the green check mark at the bottom right of the screen.
• The result of the automatic procedure differs to the measured values:
• A variance of within ± 0.4 inch (1 cm) on both AB & AC is acceptable.
Calibration
186
Problems During the Automatic Laser Receiver Calibration (cont.)
Dozer Functionality Can’t be Calibrated
• The according symbol in the System Settings will only show up if the Big Combo and the dozer Sensor have been paired with the system.
To Next Page
Loading...