In page mode, vertical and horizontal directions are based on the character
orientation.
When characters are enlarged with different sizes on one line, all the
characters on the line are aligned at the baseline.
The ESC ! command can also turn double-width and double-height modes on
or off. However, the setting of the last received command is effective.
[Default] n = 0
[Reference] ESC !
44. GS $ nL nH
[Name] Set absolute vertical print position in page mode
[Format] ASCII GS $ nL nH
Hex 1D 24 nL nH
Decimal 29 36 nL nH
[Range] 0
nL
255, 0
nH
255
[Description]
Sets the absolute vertical print starting position for buffer character data in page
mode.
This command sets the absolute print position to [( nL + nH
256)
(vertical or
horizontal motion unit)] inches.
[Details]
This command is effective only in page mode.
If the [( nL + nH
256)
(vertical or horizontal motion unit)] exceeds the
specified printing area, this command is ignored.
The horizontal starting buffer position does not move.
The reference starting position is that specified by ESC T.
This command operates as follows, depending on the starting position of the
printing area specified by ESC T:
①When the starting position is set to the upper left or lower right, this
command sets the absolute position in the horizontal direction.
②When the starting position is set to the upper right or lower left, this
command sets the absolute position in the vertical direction.
The horizontal and vertical motion unit are specified by GS P.
[Reference] ESC $, ESC T, ESC W, ESC \, GS P, GS \
45. GS * x y d1...d(x × y × 8)
[Name] Define downloaded bit image
[Format] ASCII GS * x y d1...d(x ╳ y ╳ 8)
Hex 1D 2A x y d1...d(x ╳ y ╳ 8)
Decimal 29 42 x y d1 ...d(x ╳ y ╳ 8)
[Range] 1 ≤ x ≤ 255
1≤ y ≤ 48
x ≤ y ≤ 912
0 ≤ d ≤ 255
To Next Page
