[Description] Sets the printing area width to the area specified by nL and nH.
• The printing area width is set to [( nL + nH
╳
256) ╳ horizontal motion unit]]
inches.
[Details] • This command is effective only processed at the beginning of the line.
• In page mode, the printer performs only internal flag operations.
• This command does not affect printing in page mode.
• If the [left margin + printing area width] exceeds the printable area, [printable
area width - left margin) is used.
• The horizontal and vertical motion units are specified by GS P. Changing the
horizontal and vertical motion units does not affect the current left margin.
• The horizontal motion unit ( x) is used for calculating the printing area width.
[Default] nL = 76, nH = 2
[Reference] GS L, GS P
55. GS \ nL nH
[Name] Set relative vertical print position in page mode
[Format] ASCII GS \ nL nH
Hex 1D 5C nL nH
Decimal 29 92 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the relative vertical print starting position from the current position in page mode.
• This command sets the distance from the current position to [(nL + nH × 256)
× vertical or horizontal motion unit].
[Details] • This command is ignored unless page mode is selected.
• When pitch N is specified to the movement downward:
nL + nH × 256 = N
When pitch N is specified to the movement upward (the negative direction), use the
complement of 65536.
When pitch N is specified to the movement upward:
nL + nH × 256 = 65536 - N
• Any setting that exceeds the specified printing area is ignored.
• This command function as follows, depending on the print starting position set by ESC T:
When the starting position is set to the upper left or lower right of the printing, the vertical
motion unit (y) is used.
When the starting position is set to the upper right or lower left of the printing area, the
horizontal motion unit (x) is used.
• The horizontal and vertical motion unit are specified by GS P.
To Next Page
Loading...
