iDiPOS TP-80 - GS P x y; Set horizontal and vertical motion units

32
[Description] Turns on or off white/black reverse printing mode.

When the LSB of n is 0, white/black reverse mode is turned off.

When the LSB of n is 1, white/black reverse mode is turned on.
[Details]

Only the lowest bit of n is valid.

This command is available for all characters,except
HRI characters
.

When white/black reverse printing mode is on, it also applied to character
spacing set by ESC SP.

This command does not affect bit image, user-defined bit image, bar code, HRI
characters, and spacing skipped by HT, ESC $, and ESC \.

This command does not affect the space between lines.

White/black reverse mode has a higher priority than underline mode. Even if
underline mode is on, it is disabled (but not canceled) when white/black reverse
mode is selected.
[Default] n = 0
50. GS H n
[Name] Select printing position for HRI characters
[Format] ASCII GS H n
Hex 1D 48 n
Decimal 29 72 n
[Range] 0

n

3, 48

n

51
[Description] Selects the printing position of HRI characters when printing a bar code.
n selects the printing position as follows:
n Printing position
0, 48 Not printed
1, 49 Above the bar code
2, 50 Below the bar code
3, 51 Both above and below the bar code

HRI indicates Human Readable Interpretation.
[Details]

HRI characters are printed using the font specified by GS f.
[Default] n = 0
[Reference] GS f, GS k
51. GS L nL nH
[Name] Set left margin
[Format] ASCII GS L nL nH
Hex 1D 4C nL nH
Decimal 29 76 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the left margin using nL and nH.