from the left side. Any remaining dots on the right side are blank.
• The data to define a user-defined character is (y ╳ x) bytes.
• Set a corresponding bit to 1 to print a dot or 0 to not print a dot.
• This command can define different user-defined character patterns by each
fonts. To select a font, use ESC !
• A user-defined character and a downloaded bit image cannot be defined
simultaneously. When this command is executed, the downloaded bit image is
• The user-defined character definition is cleared when:
⑤ The printer is reset or the power is turned off.
• When the user-defined characters are defined in font B (9 ╳ 17), only the most
significant bit of the 3rd byte of data in vertical direction is effective.
[Default] The internal character set
[Reference] ESC %, ESC ?
[Example]
• When font A (12 ╳ 24) is selected.
• When font B (9 ╳ 17) is selected.
To Next Page
