IDS 816

IDS 816 700-283-02I Issued September 2009
26
LOCATION 40 Trouble Display
LED
ON/ OFF
Action
1
ON
Enable AC fail trouble display
OFF
Disable AC fail trouble display
2
ON
Enable Comms fail trouble display
OFF
Disable Comms fail trouble display
3
ON
Enable phone line trouble display
OFF
Disable phone line trouble display
4
ON
Enable siren tamper trouble display
OFF
Disable siren tamper trouble display
5
ON
Enable low battery detection trouble display
OFF
Disable low battery detection trouble display
6
ON
Enable clock loss trouble display
OFF
Disable clock loss trouble display
7
ON
Enable engineers reset trouble display
OFF
Disable engineers reset trouble display
8
ON
Enable box tamper trouble display
OFF
Disable box tamper trouble display
9
ON
Reserved
OFF
Reserved
10
ON
Enable 485 device trouble display
OFF
Disable 485 device trouble display
11
ON
Enable bus trouble display
OFF
Disable bus trouble display
12
ON
Enable Aux. 12V trouble display
OFF
Disable Aux. 12V trouble display
13
ON
Reserved
OFF
Reserved
Default values are shaded
Location 40 determines which trouble conditions are displayed on the trouble menu. A trouble condition
is indicated by a flashing POWER LED. Not withstanding the disabling of a trouble condition from the
viewing menu the relevant code will be reported if programmed to do so.
Trouble conditions will be reported if programmed to do so in locations 118 to 120, regardless
of whether or not they are enabled for display.
The trouble condition can be viewed by holding down the [7] key for one second. See
“Viewing Trouble Conditions” in the User Manual.