To Next Page

To Previous Page

IDS 816 700-283-02I Issued September 2009

LOCATION 44 Keypad Lockout Time (Default = 30 seconds)

The value programmed into this location determines the keypad lockout period. The valid range is 0 - 255

seconds.

NOTE:

Keypad lockout is enabled by partition. See Partition Options Page 44, sub-location 5.

LOCATION 45 Keypad Sleep Delay (Default = 5 seconds)

The values stored in this location work in the same way as siren delay (table on page 27). The default

value is 11, which equates to 5 minutes.

NOTE:

This function is set individually per keypad (locations 400 to 407). After this time period, if there is no

keypad activity (on this keypad) the backlighting and all other status and alarm indicators will turn off. The

power LED and if appropriate, the arm LED will remain on.

LOCATION 46 User and Installer Code Number of Digits

This location determines whether 4 or 6 digit user / installer codes are applicable. Only a value of four or

six may be programmed into this location. By default, all codes are four digits in length.

The value programmed into this location has no effect on the download code, which is always 4 digits in

length.

Code

Old Four-digit Code

New Six-digit Code

All Previously

Programmed Codes

XXXX XXXX00

Installer Code 9999 999999

Master User Code 1 1234 123456

8. System Reporting Codes (4 x 2 and Domestic)

For all these locations, a two digit hexadecimal code must be programmed. To disable a reporting code

a double zero (00) must be entered into the corresponding location. Note that if one of the above-

mentioned reporting digits is inadvertently omitted or programmed as a zero, the code will not be

reported. The exception to this rule is when using domestic reporting where only the first digit is used.

LOCATION 47 AC Failure Reporting Code

The control panel will transmit this code in the event of an AC failure but only after the AC failure delay

time has elapsed (location 39).

LOCATION 48 AC Restoral Code

The control panel will transmit this code once the AC restore delay time has elapsed. (location 39). It will

however only be reported if an AC failure was registered as per location 47.

IDS 816 Installer Manual

Other manuals for IDS 816