To Next Page

To Previous Page

IDS 816 700-283-02I Issued September 2009

LOCATION 49 Low Battery Reporting Code

A low battery condition is reported when the battery voltage drops below 11.8V for a period longer than 5

minutes or immediately if it drops below 10V.

LOCATION 50 Battery Restore Reporting Code

This code is reported once the battery voltage rises above 12 volts for a period of five minutes.

LOCATION 51 Auto Test Reporting Code

This code is reported at regular intervals. (location 112)

LOCATION 52 Download Access Reporting Code

This code is reported once successful access to the panel has been obtained.

LOCATION 53 Siren Trouble Reporting Code

This code is reported when the siren fuse blows or when the siren or siren wiring is tampered with.

LOCATION 56

Device Tamper Reporting Code

This code is reported when there is a tamper condition on any external device attached to the keypad

bus.

LOCATION 57

Keypad Bus Failure Reporting Code

This code is reported when there is a fault on the keypad bus

LOCATION 58 Box Tamper Reporting Code

This code is reported when the box tamper contacts are open for a period exceeding 200 ms.

LOCATION 59 Dedicated Panic Reporting Code

This code is reported when the dedicated panic zone is violated.

LOCATION 60

Phone Line Restoral Reporting Code

If phone line monitoring is enabled (location 38), this code is reported once phone line integrity has been

restored to indicate that the phone line has been tampered with.

LOCATION 61

RF Jamming Reporting Code

This reporting code will be reported if the RF receiver module detects a jamming signal for a period

exceeding 30 seconds.

LOCATION 62

RF Jamming Restore Reporting Code

This reporting code will be reported once the jamming signal has ceased for a period exceeding 30

seconds.

IDS 816 Installer Manual

Other manuals for IDS 816