IDS X Series - Location 71 to 78: Secondary Account Codes; Location 56: Time between Dial Attempts; Location 61 to 68: Primary Account Codes Per Partition

IDS X-Series Training v2.7 | Communication Settings
39
Location 56: Time between Dial Attempts
Location Type: Standard
If the alarm fails to report to the basestation, it will wait this length of time before trying to dial out again.
Data Format: mmss
Valid Range: 0001 - 5959
Default: 0010
Location 61 to 68: Primary Account Codes per Partition
Location Type: Standard
The account code is what identifies the alarm system to the security company so that they can respond to
the correct customer. It is by default a four digit number but can be changed in location 24 to a six digit
number.
Exercise: Enter an account code 0123
Instructions
Key presses
Enter location 61
[6][1] [*]
Enter the account Code
[0] [1] [2] [3] [*]
Note: If the account code is 0000 no reporting will take place. This also allows you to configure
which partitions report and which do not.
Location 71 to 78: Secondary Account Codes
Location Type: Standard
The secondary account code is used if dual reporting is enabled and the second telephone dialled must
have a different account code to the primary account code.
Note: If the account code is 0000 no reporting will take place. This also allows you to configure
which partitions report and which do not.