IDS X-Series Training v2.7 | Standard Remote Transmitters
Option 21 - Adding Remotes - Advanced Method
The advanced method allows each button to be taught to different user codes as an arm / disarm button.
Management button is the button that you are teaching to a user code to be the arm / disarm button for
that user code.
Example:
IDS Remote Transmitter button number assignment:
Option 22 - Deleting Remote Transmitters
Each remote transmitter is assigned to a user code, therefore to delete a remote transmitter the user code
must be entered.
Example:
All user codes must be added into the system before
Press and hold the [*] key for 3 seconds
Enter the master code followed by the [*] key
Enter the value to add remotes using the advanced method, followed by the [*] key
Enter the remote receiver ID that the transmitter will be taught to, followed by the [*] key
Now enter the user code or user slot number, followed by the [*] key
Enter the management button number, followed by the [*] key
Press the [*] key when ready to teach remote transmitter
Press the button on the remote transmitter that will belong to that management button number
until the beep
When complete press the [#] key
This will leave you in the master menu
Press and hold the [*] key for 3 seconds
Enter the master code, followed by the [*] key
Enter the value to delete a remote transmitter, followed by the [*] key
Enter the remote receiver ID that the transmitter was taught to, followed by the [*] key
Now enter the user code or user slot number, followed by the [*] key
When complete press the [#] key
This will leave you in the remote receiver menu
To Next Page
Loading...
Need help?
General
