Ier N0C902A - OPENING AND CLOSING THE CUTTER;BURSTER MODULE

IER 560 COMBO PRINTER
User Guide
Page 16
N0C902A Rev. 2
Sept. 14, 2010
Ce document est la propriété d’IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated
without prior written authorization
1.5. OPENING AND CLOSING THE CUTTER/BURSTER
MODULE
1.5.1. PRELIMINARY INFORMATION
!
ATTENTION
The cutter/burster module must remain closed.
Open the cutter/burster module only when
absolutely necessary, specifically during
maintenance or when solving a problem.
It is imperative to close the cutter/burster
module during printer use.
 To open the cutting/bursting module (1), pivot the
module completely in an outward direction.
 To close the cutter/burster module (1), rotate it back
the opposite way; a light click will be heard.
CAUTION