Ier N0C902A - CONNECTING AND POWERING THE PRINTER; PRINTER CONNECTION PROCEDURES

IER 560 COMBO PRINTER
User Guide
Page 26
N0C902A Rev. 2
Sept. 14, 2010
Ce document est la propriété d’IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated
without prior written authorization
2 CONNECTING THE PRINTER AND POWER-UP
2.1. CONNECTING THE PRINTER
!
DANGER
▪ This appliance must be grounded.
▪ This product must exclusively be
connected to an electrical circuit that:
- includes a Ground Fault Circuit Interrupter
(GFCI) and is compliant with IEC 364 and
NFC15-100 regulations, and
- conforms to the voltage characteristics
specified by the NF EN 50160 standard.
2.1.1. PROCEDURE FOR CONNECTING THE PRINTER
To connect the printer, simply proceed as follows:
 Connect it to the power source
 Connect it to the data communications system (PC,
network)
WARNING