Ier N0C902A - POST-MAINTENANCE PRINTER SETUP

IER 560 COMBO PRINTER
User Guide
Page 60
N0C902A Rev. 2
Sept. 14, 2010
Ce document est la propriété d’IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated
without prior written authorization
6.3. RETURNING THE PRINTER TO OPERATING
CONDITION AFTER PERIODIC MAINTENANCE
6.3.1. PROCEDURE TO FOLLOW PRIOR TO OPERATING THE
PRINTER
After performing the periodic maintenance operations:
 Allow the printer cleaning product to dry.
 Rotate the cutter/burster module into its original position,
see page 16.
 Close the printer cover, see page 14.
 Connect the data cable and power cable, see page 26.
 Power up the printer, see page 30.
 Load the printer with paper, see page 32.
 Print a document and check the print quality, see
page 46.