Ier N0C902A - MEDIA INSTALLATION AND HANDLING; ATB MEDIA INSTALLATION AND LOADING

IER 560 COMBO PRINTER
User Guide
Page 32
N0C902A Rev. 2
Sept. 14, 2010
Ce document est la propriété d’IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated
without prior written authorization
3 INSTALLING AND LOADING THE MEDIA
3.1. ATB MEDIA
Note: The installation and loading of blank fanfold or roll type
ATB media is performed in the lower channel (L channel)
and the mid-lower channel (ML channel) of the printer (see
page 22).
IMPORTANT: Use of the motorized stacker does not allow
processing of ATB wallets as they might cause
document jams.
3.1.1. INSTALLATION OF BLANK MEDIA
3.1.1.1. Media Installation Procedure

 Power up the printer. The ONLINE indicator
located on the printer's front panel lights up
(see page 30).

 Install the box(es) of blank media by following
the instructions below:
IMPORTANT: Install the box(es):
▪ parallel to the printer
▪ centered in relation to the insertion slot
▪ with the heat-sensitive side of the media
facing up