IER 560 COMBO PRINTER
User Guide
Page 4
N0C902A Rev. 2
Sept. 14, 2010
Ce document est la propriété d’IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated
without prior written authorization
NORWAY: This product is also designed for IT power distribution system with
phase-to-phase voltage 230V.
NORWAY – SWEDEN – FINLAND: Apparaten skall anslutas till jordat uttag när
den ansluts till ett nätverk.
THIS APPLIANCE MUST BE GROUNDED.
THIS PRODUCT MUST EXCLUSIVELY BE CONNECTED TO AN
ELECTRICAL CIRCUIT THAT IS:
PROVIDED WITH A GROUND FAULT CIRCUIT
INTERRUPTER (GFCI) COMPLYING WITH IEC 364 AND
NFC15-100 REGULATIONS, AND
CONFORMING WITH THE VOLTAGE CHARACTERISTICS
SPECIFIED BY THE NF EN 50160 STANDARD.
The cover(s), door(s) and/or drawer(s) of this product is (are) intended for occasional use
and must be normally closed.
The information and specifications contained in this document are subject to change
without prior notice.
Translated from French - IER Documentation Department
This document contains proprietary information of IER. It may not be reproduced or
communicated without prior written authorization of IER. It is intended solely for the use
of the product described herein, to the exclusion of any other usage.
It is provided as is, for information purposes only, without any warranty of any kind,
including any warranty of fitness or a particular purpose, and may be modified by IER at
any time.
The warranty shall be null and void in case of use of any spare part, special tool or consumable not
expressly approved in writing by IER and in the event of attempted repair or servicing of the
machines by persons lacking the requisite technical qualifications.
To Next Page
Loading...
