41
ifm Programming Manual ecomatmobile BasicController (CR0403) Runtime System V03.02 2015-04-01
Configurations Set up the runtime system
>
4.1.2 Update the runtime system
13269
An older runtime system is already installed on the device. Now, you would like to update the runtime
system on the device?
14158
NOTICE
Risk of data loss!
When deleting or updating the runtime system all data and programs on the device are deleted.
► Save all required data and programs before deleting or updating the runtime system!
3084
When the operating system software or the CODESYS runtime system is considerably improved, ifm
releases a new version. The versions are numbered consecutively (V01, V02, V03, ...).
Please see the respective documentation for the new functions of the new software version. Note
whether special requirements for the hardware version are specified in the documentation.
If you have a device with an older version and if the conditions for the hardware and your project are
OK, you can update your device to the new software version.
For this operation, the same instructions apply as in the previous chapter 'Reinstall the runtime
system'.
>
4.1.3 Verify the installation
14637
► After loading of the runtime system into the controller:
• Check whether the runtime system was transmitted correctly!
• Check whether the correct runtime system is loaded in the controller!
► 1st test:
Test with the ifm maintenance tool if the correct runtime system version was loaded:
• Read name and version of the runtime system in the device!
• Manually compare this information with the target data!
► 2nd test (optional):
Check in the application program if the correct runtime system version was loaded:
• read name and version of the runtime system in the device!
• Compare this data with the specified values!
The following FB serves for reading the data:
GET_SW_INFO (→ page 190) Delivers information about the system software of the device:
• software name,
• software version,
• build number,
• build date
>
To Next Page
Loading...
