IFM Electronic DP2200 - Electrical Connection

13
UK
6 Electrical connection
WARNING
The device must be connected by a qualified electrician�
The national and international regulations for the installation of electrical
equipment must be adhered to�
Voltage supply to SELV, PELV�
WARNING
► Protect the supply voltage�
Potential M12 connector (1) Fuse
L+ / supply voltage pin 1 ≤ 2 A time-lag
► Alternatively supply the device via a limited energy circuit according to
IEC 61010-1�
► Disconnect power�
► Connect the device according to the table below�
2
1
43
2 1
3
1 2
4
5
Pin 4-pole M12 connector (1)
1 L+ / supply voltage
2 OUT2: analogue output
3 L- / supply voltage
4 OUT1: digital output (SIO) / IO-Link
Pin 5-pole M12 socket (2)
1 L+ / sensor supply
2 Analogue input (4���20 mA)
3 L- / sensor supply
4 Not used
5 Not used
1: Evaluation side
2: Sensor side
Always use the intended connection cables to connect sensors or other
devices with the device�
See also application examples (→ 3 Functions and features)