IFM Electronic DP2200 - Dis ─ Refresh Rate of the Displayed Value; Lo;Hi ─ Min;Max Measured Input Values

23
UK
► Select [cFH] and set the upper limit�
Setting range corresponds to the measured values� The lowest setting value is
[cFL]�
► Select [cFL] and set the lower limit�
Setting range corresponds to the measured values� The highest setting value
is [cFH]�
cFL cFH
gn gn
rd
4 mA 20 mA
cFL cFH
rd rd
gn
4 mA 20 mA
Function [r-cF]
For b/w printouts: gn = green, rd = red
Function [G-cF]
8.4.9 diS ─ refresh rate of the displayed value
• [OFF] = the measured value display is deactivated in the operating mode�
• [d1] = update of the measured values every 50 ms�
• [d2] = update of the measured values every 200 ms�
• [d3] = update of the measured values every 600 ms�
Even with an unsteady current value, [d1] provides optimum readability�
8.4.10 Lo/Hi ─ min/max measured input values
• [Lo] = minimum measured value
• [Hi] = maximum measured value
Delete memory:
► Select [HI] or [Lo]�
► Press and hold [▲] or [▼] until [----] is displayed.
► Briefly press [●].