IFM Electronic DP2200 - 3�3 Use as a Stand-Alone Device Without IO-Link

8
• As IO-Link device
The device operates as an "analogue/IO-Link converter"�
The evaluation of the measured current value depends on the parameters
which are set with IO-Link tools or a PLC via IO-Link communication or directly
on the device�
In some points parameter setting via IO-Link tools or PLC is different from
parameter setting via the menu (→ 8 Parameters)�
3.3 Use as a stand-alone device without IO-Link
The device compares the measured current value with the set parameters and
switches its output according to the selected function (→ 7 Operation).
The measured value is shown on the alphanumerical display� The displayed value
can be scaled by the user (2-point scaling)�
3
2
bar
4...20 mA
24 V DC
1
4
5
6
24 V DC
4...20 mA
M
OUT1
Application example without IO-Link master
1: Sensor with analogue output (e�g� pressure sensor)
2: Threshold display
3: Digital output
4: Looping through an analogue input signal
5: Control monitor
6: Relay output for switching
electric motors, valves etc�