IFM Electronic DP2200

3

UK

8�4 Parameters of the extended functions (EF) �� 19

8.4.1 rES ─ restore factory setting ��19

8.4.2 A.trm ─ analogue termination for OUT2 ��19

8.4.3 ou1 ─ output function for OUT1 ��19

8.4.4 dS1/dr1 ─ switching delay/switch-off delay for OUT1��19

8.4.5 ScAL ─ scaling of the displayed value ��19

8�4�6 C�ASP/C�AEP - customer-specific analogue start/end point ��20

8.4.7 coLr ─ display colours and colour changes �� 22

8.4.8 cFH/cFL ─ upper/lower value for colour change ��22

8.4.9 diS ─ refresh rate of the displayed value ��23

8.4.10 Lo/Hi ─ min/max measured input values �� 23

8.4.11 dAP ─ damping �� 24

8�5 Parameters via IO-Link ��24

8�5�1 C�uni – customer-specific unit ��24

8�5�2 S�Loc – software locking ��24

8�5�3 Application-specific tag ��24

8�5�4 Reset [Hi] and [Lo] memory �� 24

9 Parameter setting ��25

9�1 Parameter setting in general ��25

9.2 Programming example [ou1] ─ output function for OUT1��25

9�3 Notes on programming ��26

9�3�1 Lock / unlock ��26

9�3�2 Timeout �� 27

9�3�3 Change from the main menu to the extended functions menu ��27

9.3.4 Numerical entries with [▼] or [▲] �� 27

10 Scale drawing ��28

11 Technical data ��28

11�1 IO-Link device ��29

11�2 Approvals/standards ��29

11�2�1 Reference to UL �� 30

12 Fault correction ��31

IFM Electronic DP2200 - Page 3