18
8.1 Parameter setting via PC and IO-Link interface
The interface connects sensors with IO-Link capability to a PC and provides the
following options via the IO-Link interface:
• Reading of the current parameter setting�
• Parameter setting of the sensor�
• Reading of the current measured values and further process values�
The interface is not suitable for permanent installation as an automation device�
8.2 Parameter setting via the memory plug
Via a memory plug (→ accessory), a parameter set can be written/transferred to
the unit�
The memory plug can also be used to save the current parameter setting of
a unit and to transfer it to other units of the same type�
8.3 Parameter setting during operation
Parameter setting during operation requires the connection to a module
(master) with IO-Link capability (→ 7.1)�
To Next Page
Loading...
