UNO Synth PRO X
3 – Front Panel Interface
16
3.5 – LFOs
LFO 1 / LFO 2 Toggle
Selects which of the two LFOs is currently being edited.
WAVE
Hard switch between Sine, Triangle, Falling Sawtooth, Rising Sawtooth, Square, Random, S&H, Noise.
RATE
Selects the speed of the LFO 1 from 0.01 Hz to 100 Hz. When the sync is enabled, the Rate is synchronized to
the tempo and the rate is displayed in BPM.
FADE IN
This parameter controls how much time it takes for the LFO amplitude to rise from zero to maximum. The value
is expressed in seconds from 0.0 to 10.0 (one decimal place).
SYNC
An ON/OFF control. When ON, the LFO rate synchronizes to the tempo with the following musical note
subdivisions: 1/1 1/2, 1/4, 1/4d, 1/4t, 1/8, 1/8d, 1/8t, 1/16, 1/16d, 1/16t, 1/32, 1/32d, 1/32t, 1/64, 1/64d, 1/64t,
1/128.
CURVE
This parameter selects the type of curve to apply at the Fade In time between Linear, Logarithmic and
Exponential.
RETRIG
An ON/OFF control, which resets the phase of the LFO each time a key is pressed.
To Next Page
Loading...
Need help?
General
