UNO Synth PRO X
4 – Global Controls
30
4.2 – Setup
The setup menu is where the global utility settings are selected. Machine settings includes MIDI and system
management.
4.2.1 – Master Tuning
In this first voice of the menu, you can select the Master Tuning between +/-50 cents from the standard A at 440
Hz.
4.2.2 – MIDI
UNO Synth PRO X transmits the front panel knob and button movements via Control Change messages (CC),
and also receives CC messages for external control.
Each parameter or control on the synth has its own unique Control Change number, so you can completely
control the unit via external controllers or computers.
MIDI data can also be exchanged between the UNO Synth PRO X and a computer using a USB cable.
CHANNEL IN
Between 1 and 16.
CHANNEL OUT
Between 1 and 16.
SOFT THRU
The MIDI Soft Thru functionality, when enabled, allows messages from the MIDI IN DIN of the unit to be copied
to the MIDI OUT DIN.
INTERFACE
When the MIDI Interface Mode is enabled, the MIDI messages incoming from the USB are copied to the MIDI
OUT DIN of the unit and the MIDI messages incoming from the MIDI IN DIN are copied to the USB.
PROGRAM CHANGE
Program Change messages allow the recall of a preset without touching the interface. You can enable and
disable the receive and transmit of Program Change messages.
To Next Page
Loading...
Need help?
General
