UNO Synth PRO X
3 – Front Panel Interface
23
3.8.2 – Delays
TYPE (SHIFT + AMOUNT)
Selects between MONO, STEREO, DOUBLER, PING PONG and LCR. Stereo is the default delay.
TIME
Adjusts the delay tempo and division. When sync is off, the tempo goes from 1 ms to 350 ms without decimal
values. When sync is on, the values are 1/4, 1/8 T, 1/8 D, 1/8, 1/16 T, 1/16 D, 1/16, 1/32T, 1/32 D, 1/32 (some
divisions depend on the master tempo).
Synced values are the default.
NOTE: The maximum total delay time is 1 second, which becomes 500 ms for stereo delays and 350 for LCR.
For this reason, available time divisions depend on the delay type and BPM.
Depending on the type, separate L and R times might be shown.
FEEDBACK (SIZE knob)
Adjusts the delay feedback from 0% to 80% (where 100% is near auto oscillation).
FILTER
Adjusts the LPF cutoff from 20 Hz to 10000 Hz.
SYNC
Enables or disables the sync of the delay division to the master tempo. This control can be found inside the
PRESET EDIT MENU.
To Next Page
Loading...
Need help?
General
