UNO Synth PRO X
4 – Global Controls
36
4.4 – SEQUENCER
The sequencer is a 64-step sequencer capable of recording notes, chords and parameters.
Recording options are REALTIME and STEP.
Majority of the editing parameters can be recorded in the sequencer, plus some additional sequencer-only
parameters such as Accent, Tie and Gate.
Activate sequencer
When PLAY is pressed and the playback of the sequencer starts.
Everything is active apart from the ARP. To record the ARP into the sequencer you must start with the
arpeggiator first.
Exit sequencer
You must cease playback to exit the sequencer.
Realtime Recording
To enter the real-time mode recording hold REC and press PLAY.
The REC button LED starts blinking and the PLAY and SEQ LEDs light up.
From now on, every note and parameter received as input is recorded as step information, smoothed between
steps, differently from the step mode recording.
The real-time recording stops itself at the end of a loop, switching to Step Recording.
To return in Realtime recording, always hold REC and press PLAY.
Step Recording
The Step recording is activated when REC is engaged; once activated, holding a step will let you insert data
in that step, which could be notes, chords and parameters or combinations of those. To move between steps
simply hold different steps.
The Step Recording always overrides the real-time recorded elements.
Modify Step Data
To view the data stored in a step, hold a step: the display will show the data in a list scrollable via DATA encoder.
To modify a parameter, activate the recording by pressing REC, hold the desired step and scroll with DATA to
highlight the desired parameter; PUSH to enter the parameter editing and adjust with the DATA. Once finished,
release the step.
To Next Page
Loading...
Need help?
General
