UNO Synth PRO X
4 – Global Controls
37
4.4.1 – Editing button and play tools
CLEAR
This is the tool used to clear the majority of the events recorded or saved.
While holding CLEAR:
• Press any step to delete all the events stored in the step.
• Press the pages to delete the entire section of the sequence.
• Press Clear while the parameter list is open to clear the selected parameter.
COPY
While holding COPY, press any step to copy the events, or press a page to copy the entire page.
PASTE
While holding PASTE, press any step to paste copied events on another step, or press another page to paste
the entire page.
SWING
Use DATA to select between value 50% (default) until 80%. The swing value is global for both ARP and SEQ.
GATE
After pressing Gate, press any step to insert a gated note. A gated note is any note recorded in the sequencer,
but with a shortened length with selection between OFF and 10.
ACCENT
After pressing ACCENT, press any step to add an accent modulation and use the DATA knob to determine the
amount of accent between 0 and 127.
TIE
This control operates only in LEGATO, and you can switch it ON/OFF. After pressing TIE, press any step to add
a tied note, hence a legato note from the pressed step to the following.
LENGTH
To modify the length of the sequencer, press the SHIFT + any page button and adjust the length with the DATA
encoder.
TRANSPOSE
Sequences can be transposed +/- 1 octave. Pressing SHIFT + OCTAVE UP the display will show the transpose
value, by default on 0 st (semitones).
You can use the onboard keyboard to transpose the sequence, or an external keyboard if connected.
To Next Page
Loading...
Need help?
General
