UNO Synth PRO X
4 – Global Controls
29
4.1.3 – Load a preset
To Load a preset, the PRESET button has to be lit, meaning preset operations are enabled. Turning the DATA
knob will show the preset lists, but only PUSH will load the preset. BACK discards the operation.
After the PUSH, you can choose to load the sound, the sequence or both part of the preset.
That might give you an extra inspiration.
4.1.4 – Rename a preset
While storing a preset, or in the preset menu, you can rename a preset.
The rename process is done letter by letter, using the DATA rotation to select the letter, the PUSH to move to the
next character, the BACK to move to the previous character and STORE to confirm the rename.
The characters are always capital, starting with a space then numbers from 1 to 0, then letters in alphabetical
order, then symbols as follows:
-space- ,1…0, A…Z, .-_
4.1.5 – Initialize a preset
To initialize a preset, enter the EDIT PRESET menu, the last selection is INITIALIZE. You will be asked to confirm
the initialization: use BACK to discard or push DATA to confirm.
Please note: Once initialized a preset cannot be restored.
4.1.6 – Recall a preset
All parameters of a preset can be changed at any given time for sound design and performance purposes, and
a preset is not stored until the procedure is used. At any given time, you can recall the original selected and
loaded preset in real-time by pressing SHIFT + PRESET.
To Next Page
Loading...
Need help?
General
