The StellarMate X Manual
110
/
260
So just set when you want the meridian flip to occur at the mount module. Remember that
the setting is in
Hour Angle (HA)
. 1 HA = 15 degrees, therefore 0.1 HA = 1.5 degrees
West of the Meridian.
Always use a positive value to ensure proper meridian flip takes place. Using zero
could
theoretically
work but it is at the very edge where the decision to flip or not is made
by the mount, so it's
safer
to use a slightly higher value like 0.1 HA.
Auto Park
To enable auto park every day, check the Every day box. Otherwise if the desire is only to
park it once, keep it disabled.
Select the time you want to park the mount.
To Next Page
Loading...