The StellarMate X Manual
168
/
260
Direct HDMI Connection
Note
You must first complete the
First Time Setup
guide before proceeding with this
tutorial.
By default, StellarMate operates in HotSpot mode. Even if configured for WiFi connection
or LAN, StellarMate always switches back to HotSpot mode when the other connection
modes become unavailable. This is to enable you to always access the device regardless
of network availability.
StellarMate gadget is shipped with a 1.8 meters HDMI cable. Connect the cable to any
monitor or TV. Make sure the cable is connected to StellarMate
before
powering on the
unit.
Unless the HDMI connection purpose is for viewing only, you also need a keyboard +
mouse to control to the StellarMate OS. You can use wired or wireless mouse and
keyboards.
StellarMate unit is shipped with a full-featured Linux® Operation System that you can
directly access. The default username and password are:
username
:
stellarmate
password
:
smate
To Next Page
Loading...
Need help?
General