iKarus StellarMate X - Stellarmate Control Panel; Status Bar

The StellarMate X Manual
239 / 260
StellarMate Serial Assistant is only applicable to Serial-To-USB devices, for
regular USB devices, do not use it.
StellarMate Control Panel
IMPORTANT
In order to open the StellarMate Control Panel you need to be connected to the
same network as your StellarMate.
If StellarMate is in hotspot mode, you can connect to it by going to your
computer/laptop WiFi settings and connecting to the SSID stellarmate with
the password stellar@mate
Do not open StellarMate Control Panel from StellarMate itself, it is meant to be
opened from your computer/laptop.
StellarMate Control Panel is a web application for StellarMate OS. It provides any functions
such as displaying the connection status of the controller, backup and restore, network and
factory reset, etc.
Status Bar
The Status Bar is available on every page on the top-right corner as it is informative to the
user and has some shortcuts.
The Status Bar has the following features:
· Shows the connection status
· Shortcut to update StellarMate OS build
· Shows the type of connection to StellarMate (Hotspot, WIFi or ethernet)
· Shows the Date and Time
· Allows shutting down or restarting StellarMate
If the connection is spotty and keeps getting disconnected, the status bar will inform you by
showing a yellow exclamation icon.
To update using the status bar, click on the update icon and a dialog will pop-up, allowing
you to check for an update and install it.