The StellarMate X Manual
179
/
260
In here you need to select if your equipment is attached to StellarMate or elsewhere:
1.
If you are running Ekos
within
StellarMate OS, then select Equipment is attached to
this device.
2.
If you are running Ekos on a PC/Mac, then select Equipment is attached to a remote
device.
If you clicked on Equipment is attached to a remote device, this page will show up, click on
StellarMate.
If you clicked on Equipment is attached to a remote device before, this page will show up.
In this page you have a choice to specify the StellarMate Address & Port. These settings
are for advanced usage of StellarMate, so just click the Next.
To Next Page
Loading...