07
Charge the battery completely before using the Meter
for the first time.
Do not open or manipulate the Meter.
Do not pierce or burn the battery.
Do not change the battery. The manufacturer will not
warrant Meters that have been opened.
For battery replacement or meter repairs,
the equipment must be sent to the manufacturer.
Use only the supplied charger and wall power adapter
provided by the manufacturer or you may damage the
Meter.
2.4 SETTING THE TIME & DATE
Before using the microINR System, check that the
Meter’s time and date are correct, since those are
necessary to determine the Chips’ expiration date.
Those parameters are set during the manufacturing process,
so it probably will not be necessary to change them.
Time format: 24 hours. Date format: DD-MM-YYYY.
Follow the steps described below to change the Meter’s time
and date. Change only the digits needed to be set and confirm
the rest digits:
• Press and hold the left and right buttons (E and M) at the
same time for 10 seconds until the time field flashes.
• Press the left button (E) to set the hour.
• After selecting the correct hour, press the right button (M) and
set the minutes.
• After selecting the minutes, press the right button (M) again
and the date fields will start flashing.
• Use the left button (E) to select the correct day.
• When you reach the correct day, press the right button (M) to
set the month. Use the left button (E) to select the correct month.
• When you reach the correct month, press the right button (M) to
set the year. Use the left button (E) to select the correct year.
• After setting the month, time and date, press the right button
(M) again to save your settings.
If the time and date setting is mistakenly initiated or a digit is
unintentionally changed, the Meter will automatically exit that
setting without saving any change aer 10 seconds of inactivity.
2.5 PATIENT IDENTIFICATION (OPTIONAL)
microINR Link Meter can optionally record a result together
with its Patient Identification (PID). To identify the patient, take
the following steps before conducting a test:
• Hold the right button while inserting a Chip and release it
afterwards. Upon releasing the button, “PID” and a
16-character alphanumeric field will be displayed.
• To enter the characters corresponding to the PID:
- The first field will flash when selected.
- To enter the first character, press the le button (E) until
you reach the desired character.
- Validate the character with the right button (M) and go to
the next field.
To Next Page
Loading...
Need help?
General
